Standard Horizon CP180 Manual do Utilizador

RADAR OPERATION MANUAL

Page 12 Radar Operation ManualFigure 2.3 - Selection of active window3. Move the ShuttlePoint knob to highlight the desired window and press [ENT]. T

Radar Operation Manual Page 133. OPERATIONS3.0 WARMING UPThe Radar needs time from 90 to 120 seconds to heat up the magnetron (microwaveemitting tube)

Page 14 Radar Operation Manual3.1 SET UPAfter the Radar Antenna is installed, select FULL PAGE and perform the following stepsin the order shown belo

Radar Operation Manual Page 1512. Move the ShuttlePoint knob down to highlight MBS and adjust to 000 by moving theShuttlePoint knob to the right.13. M

Page 16 Radar Operation Manual1. Select the Full Page Radar window (see Par. 2.0).2. Turn the external Radar Switch On. After the magnetron warms up

Radar Operation Manual Page 17Figure 3.1.2 - Save Tuning3. Move the ShuttlePoint knob to highlight SAVE TUNING TO C-CARD and press [ENT].4. The file n

Page 18 Radar Operation ManualFigure 3.1.4 - Heading Line (I)d. Press [CLR] until the Radar page is shown.2. Select a target about 1- 2NM and adjust

Radar Operation Manual Page 19Figure 3.1.5 - Antenna Position setting2. Move the ShuttlePoint knob to highlight ANT PARKING and press [ENT].3. Use the

Page 20 Radar Operation Manual

Radar Operation Manual Page 214. UNDERSTANDING THE RADAR DISPLAYNEWSFigure 4 - Example of Radar Display page4.0 RADAR WINDOW4.0.0 CursorWhen on the Fu

Page 4 Radar Operation ManualCopyright 2008. STANDARD HORIZON All rights reserved. Printed in Japan.No part of this publication may be reproduced or

Page 22 Radar Operation ManualFigure 4.1.0 - Range selection by Soft Key4.1.1 Motion ModeAllows choosing between two different presentation of target

Radar Operation Manual Page 234.1.4 Cursor WindowThe content of the Cursor Window depends on cursor location.It shows detailed information of the curs

Page 24 Radar Operation ManualMarker is updated each time the Radar image is updated. It can temporarily be hidden to checkfor small targets under it

Radar Operation Manual Page 25spacing are adjusted automatically accordingly with the Range Scale. The indication of theRange Rings interval is indica

Page 26 Radar Operation ManualStatus Bar displayed always in compact mode to allow more space for the graphical data.To enable (On) or disable (Off)

Radar Operation Manual Page 27Figure 4.2.1 - Gain AdjustmentNOTE (EXCEPT CP180/CP180i)The Gain can be also controlled by pressing [GAIN] directly from

Page 28 Radar Operation Manual4.2.3 Rain ClutterReduces the effects of rain, snow, fog and cloud that can adversely affect displayed targets.To turn

Radar Operation Manual Page 29a line from the vessel’s position to the edge of the Radar picture display.EBL/VRMNEWSFigure 4.3.1 - EBL & VRMHandli

Page 30 Radar Operation ManualFigure 4.3.1b - EBL & VRM4.3.2 Parallel CursorA set of parallel lines with first line passing through the ship’s po

Radar Operation Manual Page 31Handling of Center OffsetIf the Radar is in Relative Motion mode, positioning the Cursor on the center of the Radarimage

Radar Operation Manual Page 5TABLE OF CONTENTS1. INTRODUCTION ...

Page 32 Radar Operation ManualNEWSFigure 4.3.5 - AIS Target on Full Radar pageTo turn the AIS Target display On or Off, follow this procedure:1. Pres

Radar Operation Manual Page 33NOTEThis function is only available when a optional compass heading sensor with NMEA 0183 with HDGsentence is connected

Page 34 Radar Operation Manual3. Move the ShuttlePoint knob to highlight ON or OFF and press [ENT].4.4.2 Cursor Echo (EXCEPT CP180/CP180i)AVAILABLE O

Radar Operation Manual Page 35Zone is inactive for 10 seconds after it is placed or re-sized, to avoid inappropriate alarms duringpositioning.4.5.0 Ha

Page 36 Radar Operation Manual

Radar Operation Manual Page 375. TROUBLESHOOTING5.0 The Radar page is not availableConfigure the I/O setup. Enter the I/O Connections menu, see proced

Page 38 Radar Operation Manual5.6 The Radar sensitivity appears to be lowRadar sensitivity depends on several factors. To increase sensitivity act as

Radar Operation Manual Page 396. FREQUENTLY ASKED QUESTIONS6.0 What should I do at first Radar installation?At first installation its necessary to:1.

Page 40 Radar Operation Manual6.9 What is SEA clutter (STC), and how should it be used?It is used to reduce the sensitivity and thus the clutter in t

Radar Operation Manual Page 416.18 How can I be advised of potential dangers for the navigation?Using the Guard Zone alarms.6.19 What are Guard Zones?

Page 6 Radar Operation Manual4.2.1 Gain Adjustment ... 264.2.2 Sea Clutt

Page 42 Radar Operation Manual

Radar Operation Manual Page 43INDEXAACTIVE WINDOW ... 11Adjusting Trigger Delay ...

Page 44 Radar Operation ManualPLEASE NOTEThe following "Limited Warranty" is for customers that have purchased products inthe United States

Radar Operation Manual Page 71. INTRODUCTION1.0 CONVENTIONS USEDPlease refer to the legend below:[MENU] If you see brackets around a bold and capital

Page 8 Radar Operation Manual

Radar Operation Manual Page 92. RADAR PAGES2.0 DISPLAYING THE RADAR PAGESThe Chart Plotter has the capability to select the following Radar pages*:FUL

Page 10 Radar Operation ManualWhen the Radar is connected, any Soft Key can be assigned any of the Radar pages (thedefault Soft Keys configuration ca

Radar Operation Manual Page 11The RANGE Soft KeySelects the Radar range among 1/8, 1/4, 1/2, 3/4, 1, 1 + 1/2, 2, 3, 4, 6, 8, 12, 16, 24, 36 and48 Nm (